shirlin@avrt.net 0086-577-62734829

Generator Speed Control and actuator

Speed control unit esd5220

Input Supply 12 or 24 VDC Battery System (Transient and Reverse Voltage)
Polarity Negative Ground (Case Isolated)
Power Consumption 50 ma continuous plus actuator current
Actuator Current Range @77°F (25 °C) - (Inductive Load) Min.2.5 Amps; Max. 10Amps continuous
Speed Sensor Signal 0.5-120 Volts RMS
Speed switch Relay contacts(N.O.and N.C) 10 Amps
Performance Isochronous Operation/Steady State Stability ±0.25% or better
Speed Range/Governor 1K to 7.5K Hz continuous
Speed Drift with Temperature ±1% Max
Idle Adjust CW 60% of set speed
Idle Adjust CCW Less than 1200 Hz.
Droop Range 1-5% regulation
Droop Adj. Max. (K-L Jumpered) 400 Hz., ±75Hz. Per 1.0A change
Droop Adj. Min. (K-L Jumpered) 15Hz., ±6Hz. Per 1.0A change
Speed Trim Range ±200 Hz
Remote Variable Speed Range 500 - 7.5 Hz. Or any part there of Terminal Sensitivity
Terminal Sensitivity J 100 Hz., ± 15Hz / Volt @ 5.0 K Impedance
Terminal Sensitivity L 735 Hz., ±60 Hz / Volt @ 65 K Impedance
Terminal Sensitivity N 148 Hz., ±10 Hz / Volt @ 1 Meg. Impedance
Terminal Sensitivity P 10 VDC Supply @ 20 ma Max
Speed witch adjustment range 1000-10000HZ
Environmental Ambient Operating Temperature Range -40 to +180°F(-40°+85 °C)
Relative Humidity Up to 95%
All Surface Finishes Fungus Proof and Corrosion Resitant
Reliability Vibration 1G @ 20 to 100 Hz.
Testing 100% Functionally Tested
physical Dimensions See outline (FIGURE 1)
Weigh1 1.8 lbs.(820 grams)
Mounting Any position, Vertical Preferred
Feedback